Anticondens Glas 20 L

Once dried, AntiCondens creates a hydrophilic layer on the glass that causes condensation to run off the surface, thus preventing the formation of water droplets. This provides additional light and prevents damage and diseases.

• Improved transmission increases yield and saves energy
• Two versions: for greenhouse glass and plastic film
• Water-based, safe to use
• AntiCondens lasts the entire season

More production
Droplets on the glass cause serious light loss, while a thin, even layer of condensation can actually increase light ingress. The loss of light with standard horticultural glass increases by 5% due to the formation of condensation droplets. This is a particular problem during the low light months, resulting in loss of production. As a rule of thumb, 1% more light provides 1% more production.

Application
AntiCondens should be applied on a clean, dry surface free of other substances. For one hectare, mix 60 litres of AntiCondens with 1,000 litres of clean water. Apply AntiCondens from the gutter to the top of the ridge with a fine mist until the surface is entirely moistened. After application, allow the treated surface to dry thoroughly. You can speed up the drying process by keeping the greenhouse well ventilated. If applied well, AntiCondens will remain active the entire season.

• AntiCondens should ideally be applied when the greenhouse is empty.
• If applying above the crop, test for phytotoxicity. Spray a small amount of diluted AntiCondens on the crop and check for any negative effects before starting application.